Filter
Top Products
7
Your TV can automatically set itself for local area (or cable
TV) channels. This makes it easy for you to select only the
TV stations in your area by pressing the CH + or – button
on the remote control
IMPORTANT! When you plug in your TV for the first
time it will prompt you to set the Language and
Autoprogam the channels.
If you are setting up the TV after turning it on for the first
time, skip steps 1-3. If you are returning to the
Autoprogrammenu , use steps 1-3 below..
1
Press the MENU button on the remote control to show
the on-screen menu.
2
Press the Cursor Down button repeatedly until “Install”
is highlighted.
3
Press the Cursor Right button repeatedly to shift the
menu to the left and select “Autoprogram.”
4
Press the Cursor Down button to select the “Install”
mode control.
5
Press the Cursor Right button to display a list of Install
mode options: “Antenna,” “Automatic,” “Cable.”
6
Press the Cursor Up or Down button to select one of the
options. Select “Antenna” for normal outside- or inside-
type antenna. Select “Cable” for a cable-company-sup-
plied signal. When “Automatic” is selected, the TV will
automatically set the mode based on the type of signal it
detects coming into the TV. The programming process
may be faster if you choose the specific type of connec-
tion you have made, either Antenna or Cable.
7
Press the Cursor Left button after making your “Install”
mode selection.
8
Press the Cursor Down button to select “Install.”
9
Press the Cursor Right button to start the programming
process. After prograomming is finished, the set will go
to trhe first channel found.
10
Press the Menu button to remove the on-screen menu
from the TV screen when the Autoprogramming process
has finished.
Autoprogram
Install mode
Install
Start
60 analog channels found
Autoprogramming is complete
Autoprogram
Install mode
Install
Antenna
Automatic
Cable
Picture Sound Features Channels
TV
Settings
Demo
Install
Language
TV
Settings
Demo
Install
Autoprogram
Install mode
Install
The TV will search for, find and store
all the available channels.
Press the cursor down to proceed.
2
4
6
8
3
5
9
7
6
Autoprogram
Install mode
Install
Automatic
Keep the prede-
fined automatic
detection of
cable or anntenna
or make your own
selection.
Autoprogram
Install mode
Install
Automatic
Autoprogram
Install mode
Install
Start
To Autoprogram Analog channels, press the right arrow.
Autoprogram
Install mode
Install
Searching
24 analog channels found
1
10
After Autoprogram is finished, check the results. Press the CH
(+) or (–) button on the remote control to see which channels
you can select.
HELPFUL HINT
Autoprogram
Using the Installation Features