Filter
Top Products
9
Starting a recording without data from the
GUIDE Plus+
®
system:
If no data is available from the GUIDE Plus+
®
system, or in case the
recording is made from a satellite receiver connected to the EXT1
TO TV-I/O , EXT2 AUX-I/O socket, the time bar will not display any
data on the beginning, end, and title of the TV show.
1 In case the time bar of the Time Shift Buffer is not visible on the
screen, press INFO on the remote control.
2 Press REC/OTR n .
P The red light around the record button n on the front will
switch on.
P '1 Programm +30' will appear on the screen on the right end
of the time bar. . This indicates that the recording will
automatically end after 30 minutes. Press
REC/OTR n several times to prolong the switch-off time.
Recording the previous TV show
If the DVD recorded has been on for some time, the Time Shift Buffer
already contains recordings. You can select those recordings (TV shows)
that you want to store on the HDD.
- Select the beginning of the oldest recording with D or C and hold
down REC/OTR n to mark the recording from the beginning.
- Select the end of the most recent recording using C or D and hold
down the RED function button to cut off the end.
You can remove the marker using the RED function button.
Starting a recording from the current position
(from here onward)
You can also start a recording immediately, regardless of the
recordings in the Time Shift Buffer.
1 Hold down REC/OTR n until the red light on the record button
n at the front switches on.
Ending a recording automatically
Recordings will be automatically ended if data from the GUIDE Plus+
®
is available or if you entered the end while starting a recording
(30-minute steps).
Ending a recording manually(immediately)
1 If necessary, switch the TV set to the programme number (input
socket) of the DVD recorder.
2 Press STOP h
P A message appears on the screen, asking whether you really
want to end the recording.
O If you want to end the recording, select 'Yes' with D and
confirm with OK .
O If you do not want to end the recording, confirm 'No' using
OK .
STOP h will always end only the current recording (current time).
If you want to end a recording earlier than scheduled (jump back in the
Time Shift Buffer using D ), proceed as follows:
- Press INFO to display the time bar.
- Hold down the red function button.
3 To permanently store the recording on the hard disk, you have to
erase the Time Shift Buffer. The following options are available:
O the preset Time Shift Buffer period expires (the default setting
is 3 hours)
O the Time Shift Buffer is manually erased ('Flush
Buffer'function( SYSTEM MENU button, 'Set up'menu ))
O you turn off the DVD recorder with STANDBY m
O you switch to camera mode using CAM (switch back with the
same function button).
ENGLISH
Quick install Guide