Filter
Top Products
User Manual BDL4251V
16
Setup Procedure
1. Install the system on the right location
CAUTION:
THE LCD MONITOR MUST BE MOVED OR INSTALLED BY TWO
OR MORE PERSONS.
Failure to follow this caution may result in injury and damage when
the LCD monitor falls.
CAUTION:
DO NOT ATTEMPT TO INSTALL THE LCD MONITOR BY
YOURSELF.
The LCD display must be installed by a qualified technician. Contact
your dealer for more information.
CAUTION:
DO NOT MOUNT OR OPERATE THE DISPLAY UPSIDE DOWN,
FACE UP OR FACE DOWN.IT’S POSSIBILITY TO CLOCKWISE 90
DEGREES MOUNT. BUT DO NOT COUNTERCLOCKWISE 90
DEGREES MOUNT.
CAUTION:
DO NOT INSTALL THE LCD MONITOR WHERE IT WILL BE
EXPOSED TO DIRECT SUNLIGHT.
Failure to follow this caution will result in display defects.
IMPORTANT:
Lay the protective sheet, which was wrapped around the LCD
monitor when it was packaged, beneath the LCD monitor so as not to
scratch the panel.
2. Install the remote control batteries
The remote control is powered by 1.5V AAA batteries. To install or
replace batteries:
1. Press and slide to open the cover.
2. Align the batteries according to the (+) and (–) indications inside
the case.
3. Replace the cover.
CAUTION:
Incorrect use of batteries can result in leaks or bursting. Be careful
especially about the following points.
• Place “AAA” batteries matching the + and - signs on each battery
to the + and - signs of the battery compartment.
• Do not mix battery types.
• Do not combine new batteries with used ones. It causes shorter
battery life or leakage of batteries.
• Remove dead batteries immediately to prevent battery liquid from
leaking into the battery compartment. Don't touch exposed
battery acid, it cause damage to your skin.
NOTE:
If you do not intend to use the Remote Control for a long period,
remove the batteries.
3. Connect to external equipment
• To protect the connected equipment, turn off the main power before
making connections.
• Please refer to section “Connectivity” P.18~P.22 for operations.
4. Connect power cord
• The power outlet socket should be installed as near to the equipment
as possible, and should be easily accessible.
• Fully insert the prongs into the power outlet socket. A loose
connection may cause malfunctioning of the device.
NOTE:
Please refer to “Safety Operation” section of this manual for proper
selection of AC power cord.
5. Turn on the power of the attached
external equipment
When connected with a computer, turn on the power of the computer
first.
6. Operate the attached external equipment
Display the signal from the external equipment by selecting the correct
video and audio sources first.
7. Adjust the sound
Make adjustments to lower or to rise the volume as required.
8. Adjust the screen
Make adjustments to the display position or settings if required.