Filter
Top Products
49
EN
For fast and successful start-up, check that your receiver
is connected to the wall socket,TV set and other
equipment according to the diagrams in chapter
Connecting your receiver. Switch on the receiver and TV
set.The welcome screen appears, then the First
installation screen.
First installation settings
- Set your favourite menu language and press OK.
- Set appropriate values for the following:
• Network ID: applicable network ID as indicated
by your operator. See operator booklet for the
right decimal value to be entered for your region.
•
Frequency: broadcast frequency predefined or
entered manually as indicated by your operator
(see operator booklet).
• Symbol Rate: predefined value, which should not
be modified unless requested by your operator
•
Modulation: predefined modulation type, which
should not be modified unless requested by your
operator
Symbol rate and modulation may be modified
manually upon request by your operator.
- Press
OK to start scanning for channels.
Channel scanning
During the scanning process, the following information
is reported on screen:
• number of TV and Radio channels detected,
• name of the network detected,
• level and quality of reception of the signal.
When scanning has been successfully completed,
a completion message is displayed, and then the receiver
tunes to the first channel in the list.
First installation
DCR 2020_indice1 1/09/05 15:26 Page 49