Filter
Top Products
English
28 DVD to Videotape Duplication
Follow the steps below to copy a DVD to a videotape. This will
be possible only if the DVD is not copy protected.
Before you begin:
● Put a videotape in the cassette compartment. Make sure the
tape’s record tab is intact and the tape is long enough to record
the DVD.
● Put the DVD you want to copy in the disc tray.
● Press VCR so VCR light appears on the front of the DVD/VCR.
●
Turn on the TV and set it to the correct Video In channel.
(Check your TV owner’s manual for details.)
1
Press INPUT repeatedly until “DISC” appears on the
TV screen.
2
Press SPEED repeatedly until the desired tape
speed (SP or SLP) appears briefly on the screen.
Details about tape speed are on page 57.
3
Press REC I to start recording. “REC” will appear on
the display panel.
4
Press DVD. Press PLAY B to play the disc.
●
To pause the recording, press VCR, then press
PAUSE
k
once.
“
REC
”
will flash.
●
To r esume recording, press REC
I
or press PAUSE
k
again.
“
REC
”
will reappear.
●
To stop recording, press VCR, then press STOP
C
.
DISC
2
4
DVDVCR SETUP
INPUT
MENU
REC SPEED MODE
ANGLE SEARCH REPEAT
DISPLAY SUBTITLE ZOOM
TIMER SET
REPEAT
A-B
AUDIO
BACKPAUSESTOP
PLAY
OK
FFW
REW
CLEAR TITLE
DISC
TRACKING
OPEN/CLOSE
12
6
5
4
7
8
9
0
+10
3
•A Timer Recording or Satellite
Link is not available during DVD
to videotape duplication.
•You cannot copy a DVD to a
videotape if you are using
Progressive Scan.
Helpful Hints
1
3
E8E20UD_EN1 8/23/07 1:25 PM Page 28