Filter
Top Products
2
Unpacking and wall mounting instructions
Unpacking and wall mounting instructions
Remove the packaging
&
Open the upper carton which packages the plasma display
and remove the styrofoam.
é Remove the upper carton and open the protective sheet.
Protective sheet
Attach the display fittings
“
With the display standing in its packaging carton, align the
round holes of the display fittings with the screw holes of
the plasma display, then fasten the display fittings using the
supplied screws.
round hole
square hole
Installation of the display fittings can also be performed by
laying down the plasma display on a flat surface.
Remove the plasma display form the carton, place the
protective sheet that was used in the packaging on a flat
surface (which is larger than the display), then lay the
display down on top of this with the screen surface facing
downward.
Special technology is required in the mounting of the plasma display.
Such work should never be undertaken by the customer.
For the safety of the customer, we ask that the installation work be started after careful attention is paid to the strength of the
mounting location to be sure it will withstand the weight (about 46 kg) of the plasma display and mounting hardware.
Be sure that two or more persons engage in the installation work.
Be careful not to lose any of the removed screws or other parts.
M4 screws x 4
M4 screws x 8
wall mount unit
display fittings
Package parts list
126 1022.4 gb 20-12-2002 11:54 Pagina 2