Philips FWD182 DVD Player User Manual


 
English
11
Connections
Step 1: Placing speakers and
subwoofer
subwoofer
TV
Place the front left and right speakers at equal
distances from the TV set and at an angle of
approximately 45 degrees from the listening
position.
Notes:
–To avoid magnetic interference, do not position
the front speakers too close to your TV set.
Allow adequate ventilation around the DVD Mini
Hi-Fi System.
Step 2: Connecting speakers
and subwoofer
Speaker
(right)
Speaker
(left)
Active subwoofer
AC
IN
Connect the speaker wires to the SPEAKERS
(FRONT) terminals, right speaker to “Rand left
speaker to “L”, coloured (marked) wire to “+
and black (unmarked) wire to “”. Fully insert the
stripped portion of the speaker wire into the
terminal as shown.
Connect the subwoofer using subwoofer cable
to the SUBWOOFER OUT jack on the DVD
Mini Hi-Fi System.
Notes:
–For optimal sound performance, use the
supplied speakers.
Do not connect more than one speaker to any
one pair of +/- speaker terminals.
Use an active subwoofer only.
Do not connect speakers with an impedance
lower than the speakers supplied. Please refer to
the SPECIFICATIONS section of this manual.
IMPORTANT!
The type plate is located on the rear of
the system.
To avoid overheating of the system, a safety
circuit has been built in. Therefore, your
system may switch to Standby mode
automatically under extreme conditions. If
this happens, let the system cool down
before reusing it.
Speakers
Front Left (L)
Front Right (R)
White
Red
+
Black
Black
pg 001-044£FWD182_55_Eng 2006.3.16, 4:52 PM11