Filter
Top Products
16
English
Basic function
IMPORTANT!
Before you operate the system,
complete the preparation procedures.
Switching the system on
● Press STANDBY ON 2or SOURCE.
➜ The system will switch to the last selected
source.
● Press DISC, TUNER, TAPE or AUX on the
remote control.
➜ The system will switch to the selected source.
Switching the system to Standby
mode
● Press STANDBY ON 2 in the active mode.
➜ The backlight of display is dim in standby.
● The volume level, interactive sound setting, last
selected mode, source and tuner presets will be
retained in the player’s memory.
Power-saving automatic standby
● As a power-saving feature, the system will
automatically switch to standby mode if you do
not press any buttons within 30 minutes after a
disc or tape has stopped playing.
Demonstration mode
The system has a demonstration mode that
shows various features offered by the system.
Activating demonstration
● In Standby , press and hold STOP to activate
demo mode.
➜ “DEMO ON” is displayed.
➜ Demonstration will begin.
Deactivating demonstration
l Press and hold STOP on the system ,or press
DISC key, or press STANDBY ON key, until
“DEMO OFF” is displayed.
➜ The system will switch to DISC mode.
Note:
– Even if you remove the AC power cord and
reconnect it to the wall socket, the demonstration
will remain off until you activate it again.
Plug and Play (for tuner installation)
Plug and play allows you to store all available
radio stations automatically.
If plug and play has not been installed
1 When you turn on the system, “AUTO
INSTALL- PRESS PLAY” will be displayed.
2 Press 38 on the system to start installation.
➜ “INSTALL” will be displayed and followed by
“TUNER” and then “AUTO PROG”.
➜ PROG will start to flash.
➜ The system will search all radio stations on
the FM band, and then the MW band.
➜ All available radio stations with strong signal
strength will be stored automatically.
➜ The system will stop searching when all
available radio stations are stored or when the
memory for 40 preset radio stations is full.
➜ The first preset radio station will play when
Plug and Play is completed.
Reinstalling plug and play
1 In Standby mode, press and hold 38 on the
system until “AUTO INSTALL-PRESS PLAY” is
displayed.
2 Press 38 again to start installation.
➜ All previously stored radio stations will be
replaced.
To exit without storing the plug and play
● Press 7 on the system.
pg 001-044£≠FWD182_55_Eng 2006.3.16, 4:52 PM16