Filter
Top Products
English
31
Clock/Timer
Viewing clock
The clock (if it is set) will be shown in standby
mode.
To view the clock in any source mode
(DISC or TUNER for example), or Eco-
power standby mode
● Press briefly CLOCK on the remote.
➜ The clock is displayed for a few seconds.
➜ If the clock has not been set, "--:--" is
displayed for a few seconds.
Setting clock
1 In standby or any source mode, press and hold
CLOCK on the remote.
➜ The clock digits flash on the display panel.
➜ If the clock has not been set, "--:--" flashes
2 Press ¡ / ™ on the set repeatedly to set the
hour.
3 Press à / á on the set repeatedly to set the
minute.
4 Press and hold MODE on the front panel for
more than 5 seconds to toggle between 12-hour
and 24-hour display.
5 Press CLOCK agian to store the setting.
➜ The clock starts working.
Notes:
– The clock setting will be erased when the system
is disconnected from the power supply.
– The system will exit clock setting mode if no
button is pressed within 25 seconds.
–To exit clock setting without storing, press STOP
on the system to exit.
Setting wake-up timer
The system can switch on to DISC or TUNER
mode automatically at a preset time, serving as
an alarm to wake you up.
IMPORTANT!
– Before setting the timer, ensure that
the clock is set correctly.
–To set a new timer, you need to
deactivate the previously set timer.
1 In standby mode, press and hold SLEEP/
TIMER on the remote for more than five
seconds to enter timer setting mode.
➜ The source and timer digits will be lighted on
the display panel.
➜ “ NO TIMER “ will be displayed briefly if
wake-up timer is not set.
2 Press DISC or TUNER to select the desired
source.
● Before setting timer, make sure the music source
has been prepared.
DISC – load the disc.
TUNER – tune to the desired radio station.
3 Press ¡ / ™ repeatedly to set the hour.
4 Press à / á repeatedly to set the minute.
5 Press SLEEP/TIMER to store the time.
● At the preset time, the selected source will play.
To deactivate the wake-up timer
● In standby mode, press and hold SLEEP/
TIMER until “TIMER OFF” is displayed on the
panel.
Notes:
– The system will exit timer setting mode if no
button is pressed within 25 seconds.
– Display shows if activated, and disappears if
deactivated.
Setting sleep timer
The sleep timer enables the system to switch off
by itself after a set period of time.
1 Press SLEEP/TIMER on the remote control
repeatedly to select a preset time.
➜ The selections are as follows (time in
minutes):
15 ™ 30 ™ 45 ™ 60 ™ 90 ™120 ™ OFF
2 Press SLEEP/TIMER until you reach the
desired length of time.
To deactivate the sleep timer
● Press SLEEP/TIMER repeatedly until "OFF" is
displayed, or press the STANDBY ON y
button.
pg001-036_MCD139B_58_Eng 2007.5.18, 14:4531