Filter
Top Products
36
English
Clock/Timer
Clock setting
See "Preparations-Step 2: Setting the clock".
Timer setting
● The system can be used as an alarm clock,
whereby the last selected source is switched on
at a set time (one time operation). The clock
time needs to be set first before the timer can
be used.
1 In standby mode, press and hold TIMER on the
remote for more than three seconds.
➜ "SET TIMER" is displayed briefly. Then, the
hour digits flash on the display panel.
2 Tu rn the VOLUME control on the front panel
or press VOL +/- on the remote to set the
hours and press TIMER on the remote to
confirm.
➜ The minute digits flash on the display panel.
3 Tu rn the VOLUME control on the front panel
or press VOL +/- on the remote to set the
minutes and press TIMER on the remote to
confirm.
➜ "ON" or "OFF" flashes.
4 Turn the VOLUME control on the front panel
or press VOL +/- on the remote to activate or
deactivate the timer and press TIMER on the
remote to complete the setting.
➜ Display shows if activated, and disappears
if deactivated.
Sleep timer setting
The sleep timer enables the system to switch off
by itself after a set period of time.
1 Press SLEEP on the remote control repeatedly
to select a preset time.
➜ The selections are as follows (time in
minutes):
0FF™010 ™ 020 ™ 030 ™ 040 ™ 050 ™
060 ™070 ™ 080 ™ 090™ 0FF
➜ "SLEEP XX" is displayed. "XX" is the time in
minutes.
2 When you reach the desired length of time, stop
pressing the SLEEP button.
To deactivate the sleep timer
● Press SLEEP repeatedly until "0FF" is displayed,
or press STANDBY ON y.
TUNING
PRESET
DSC
PROGRAMMODEANGLE A-B
IS
pg001-pg04£∞_MCD515-93-Eng 2006.4.26, 10:0336