Filter
Top Products
59
COMPATIBILITY INFORMATION FOR THE TV’S HIGH-DEFINITION INPUTS
Appendix A
A
Appendix
Y
our set’s HD inputs (HD INPUT-AV 4 and
HD INPUT-AV 5) are designed to accept
high-definition signal standards 480p and 1080i
as specified by the Electronic Industries
Association. Output standards may vary by man-
ufacturer. Refer to the directions-for-use manual
for the digital equipment before connecting.
Your TV’s HD input jacks are compatible with
some digital equipment having RGB outputs with
“sync on green” or RGB with “separate H and V
sync.” As with HD component video signals, out-
put standards may vary by manufacturer. Refer to
the directions-for-use manual for the receiver
before connecting.
HD INPUT-AV 4
When the Inputs Are Used with Component Video Signals
Y INPUT: 1.0 Vp-p (includes sync), 75 ohms
Pr INPUT: 700m Vp-p, 75 ohms
Pb INPUT: 700m Vp-p, 75 ohms
NOTES:
The Pb INPUT jack can also receive signals from outputs labeled Cb or B-Y.
The Pr INPUT jack can also receive signals from outputs labeled Cr or R-Y.
When the Inputs Are Used with RGB Video Signals
G/Y: 1.0 Vp-p, 75 ohms (compatible with sync on green)
R/Pr: 700 mVp-p, 75 ohms
B/Pb: 700 mVp-p, 75 ohms
H: 3 Vp-p ± 1.0 V, 1 kohm (when using separate H and V sync)
V: 3 Vp-p ± 1.0 V, 1 kohm (when using separate H and V sync).
HD INPUT-AV 5
This input accepts a 24-pin digital visual interface (DVI) connector, which uses
digital data in the format data standard called transition minimized differential
signaling (TMDS).
• No industry standards have been estab-
lished for HD television RGB signal sys-
tems, timing, synchronization, and signal
strengths. The HD INPUT-AV 4 RGB
inputs on your Philips TV will not be
compatible with all digital equipment that
offers RGB outputs. If the digital equip-
ment you want to connect offers both
component video and RGB, component
video is the suggested type of connection
to use.
• Your TV’s onscreen INSTALL submenu
provides the option of switching the AV4
signal source between YPbPr and RGB
color-space settings. The option is avail-
able only when you have selected the
AV4 signal source (using the AV button
on the remote or the Source Select button
on the TV). The default setting for AV4 is
YPbPr. See page 61.
HELPFUL HINTS