Filter
Top Products
4
Unpacking and wall mounting instructions
Special technology is required in the mounting of the plasma display.
Such work should never be undertaken by the customer.
For the safety of the customer, we ask that the installation work be started after careful attention is
paid to the strength of the mounting location to be sure it will withstand the weight (about 97 Lbs) of
the plasma display and mounting hardware.
Be sure that two or more persons engage in the installation work.
Be careful not to lose any of the removed screws or other parts.
Remove the packaging
& Open the upper carton which packages the
plasma display and remove the styrofoam.
é Remove the upper carton and open the
protective sheet.
Package parts list
Attach the display fittings
“ With the display standing in its packaging
carton, align the square holes of the display
fittings with the screw holes of the plasma
display, then fasten the display fittings using the
supplied screws.
Installation of the display fittings can also be
performed by laying down the plasma display
on a flat surface.
Remove the plasma display form the carton,
place the protective sheet that was used in the
packaging on a flat surface (which is larger than
the display), then lay the display down on top of
this with the screen surface facing downward.
Protective sheet
M4 screws x 4
M4 screws x 8
round hole
square hole
display fittings
wall mount unit
2268.1 am 03-12-2003 09:47 Pagina 4