Filter
Top Products
yhur Cable TV input into your
ome may be a single (75
ohm) cable, or a Converter Box
installation. In either case the
connection to the TV is very easy.
Just put the threaded end of the
cable signal to the TWs antenna
plug and screw it down tight,
_If your Cable TV signal is a sin-
gle round cable (75 ohm) then
you're ready to connect to the TV.
if you have a Cable Converter
Box:
Connect the Cable TV signal to the
Cable Signal IN(put) plug on the
Converter..
<_ Connect the Cable to
TV cable the
75_ plug on theTV.
If you have a Cable Converter Box:
Connect the OUT(put)plug from the
Converter to the 75[2 plug on the "IV.
O
Remember: !
Set the TV for the
type signal you've
just,connected (see
the Tuner' section
on page 11 of this
manual.)
To select only the
channel numbers on
your Cable system
see "Auto Program"
(page 12). If you use
a Cable Converter
box, set the TV to the
same channel as the
converter's CH 3/4
switch (on the rear of
the converter.)
Cable TV Company
Back of TV
Cable TV Converter
Box Connection
Round Cable
75_ Ohm