Filter
Top Products
11
Programming the Universal Remote Control
Manually Setting the Remote to Operate a TV, VCR or DVD Player
Your remote control may already operate your TV, VCR, or DVD player. If the remote
control does not operate your TV, VCR, or DVD player, follow the steps below. These
instructions guide you through setting the remote control to operate your TV. For VCR
and DVD player, follow the same steps, but press the VCR or DVD button at step 3.
1. Point the remote control at your TV and press the TV button. Then, press the POWER
button. If your TV turns on or off, try the other TV function buttons (see page 9). If the
other functions work, the remote is ready to operate the TV without any more steps. If
your TV does not turn on or off, or if the other buttons do not work, go to step 2.
2. Find the brand of your TV pages 13-15, and list the 3-digit number here: _ _ _.
3. Press and hold the TV button until LED lights.
4. Press and hold the number 1 and number 3 buttons simultaneously for 3 seconds. The
LED will blink twice and remain on.
5. Enter the 3-digit code from step 2 within 60 seconds. The LED will blink after each but-
ton press. Note: If the 3-digit code is not entered within one minute, the LED will turn
off and the remote control will return to the previously programmed code.
6. After a valid 3-digit code has been entered, the LED will turn off and blink twice to con-
firm the new 3-digit code has been programmed. The LED will then turn off.
7. If an invalid 3-digit code has been entered, the LED will turn off.
8. Press the POWER button. If the remote control operates your TV, you’re finished.
9. If the remote control doesn’t operate your TV, repeat steps 2-8. If your TV brand has
more than one 3-digit code, try using the next code number.
10. For future reference, list the 3-digit code numbers you programmed into your remote
control:
TV code:__ __ __
VCR code:__ __ __
DVD code:__ __ __
11. If you cannot find a code that operates your TV, VCR, or DVD Player, follow the
Automatic Search Steps (see page 12).
Note: If the 3-digit code is not entered within 60 seconds, the LED will turn off and the
remote control will return to the previously programmed code.
rc1364101 (1) 4/30/03 3:41 PM Page 11