Filter
Top Products
8
The I-TV Universal Remote Control is
designed to be an enhanced replacement for
your original remote control.Although most
keys operate the same (see Key Charts on
page 3), some do differ or provide unique
features as described below.
I-TV Key
The I-TV key works just like the MENU key of
your original remote control and allows you
to access the on-screen menu of the compo-
nent you have selected (e.g., TV, VCR,DVD,
LD,CBL,or DSS).
Moreover,while in the I-TV mode,the VOL+,
VOL–,CH+,and CH– keys* will allow you to
navigate and adjust the on screen menu set-
tings just like you would with your original
remote control.
To exit out of I-TV mode, either press I-TV
again or EXIT (depending on how the origi-
nal remote control functioned) to return to
normal operation.
*NOTE: If your component’s On-Screen menu
requires the use of the Volume and Channel
keys to navigate and change the On-Screen
menu settings, press
I-TV
again while the On-
Screen menu is displayed.
GUIDE Key
The GUIDE key works just like the GUIDE key
of your original remote control and allows
you to access the On-Screen guide* of the
component you have selected (e.g.CBL,DSS,
and some newer TVs).
While in the Guide mode, the VOL+, VOL–,
CH+,and CH– keys* will allow you to navi-
gate Up, Down, Left and Right just like you
would with your original remote control.
To exit out of the Guide mode, either press
GUIDE key again or EXIT (depending on how
the original remote control functioned) to
return to normal operation.
NOTE: *On-Screen guide is an interactive
channel listings menu that is available on
most DSS Satellite systems and is also used
with advanced converters being offered by
some cable systems. This feature is not applic-
able for all DSS or cable boxes.
SELECT Key
The SELECT key allows you to choose features
displayed on your On-Screen menu while in
the I-TV mode, and programs while in the
GUIDE mode.
If your original remote control includes a
SELECT key, then the I-TV’s SELECT key will
operate in the same manner for the selected
component.
SCAN Key
The SCAN key allows the remote control to
scan the TV, VCR, CBL and DSS channels.
When activated, the remote control will
change channels every 3 seconds.
1. On the remote con-
trol, press TV, VCR,
CBL,or DSS once.
2. Press SCAN once. Scanning will
start with the current channel,
then proceed to the next channel
up, and continue until all chan-
nels of your TV,VCR,CBL or DSS
component are scanned.
3. To stop scanning channels,press
SCAN (or any key).
MCP Key
The I-TV remote control includes a multi-
component power (MCP) key that can be
programmed for master power on/off con-
trol of components using a single key.
To Program The MCP Key:
1. On the remote control, press and
hold SET until the red light blinks
twice,then release SET.
2. Enter 9-9-5.The red light will
blink twice.
3. Press MCP once.
4. Press a Component
key once (e.g., TV,
VCR, CBL,AUD, DSS,
or CD).
5. Press POWER.
6. Repeat steps 4 and 5 one or more
times for each component you
want under master power on/off
control.
7. Press and hold SET until the red
light blinks twice, then release
SET.
OPERATING YOUR REMOTE CONTROL
REM380 Manual Engl 12/28/99 12:10 PM Page 8