Filter
Top Products
English
Instructions for use
5
Setting the remote control
This is only necessary if your appliance does not respond to the RU252.
If that is the case, the RU252 does not recognize the brand and/or model of
your appliance and you need to program the remote control to do so.
The example below (TV) instructs you how to do this.You can repeat the
same steps for other appliances (VCR/DVD players/recorders) which you
want to operate using the RU252.
Example of TV:
1 Turn on the TV manually or use the original remote control.
Tune in to channel 1.
2 Look up the brand of your TV in the code list at the back of this
manual. One or more four-figure codes are shown for each brand.
Note the first code.
Be careful! There are separate tables for TV,VCR and DVD.
Make sure you use the codes from the correct table.
3 Press the RU252’s TV key to select TV.
(See ‘Testing the remote control’.)
4 Keep keys ‘1’ and ‘3’ pressed simultaneously
for three seconds until the green indicator
light remains lit.
5 Then enter the code noted in step 2 using
the digital keys.
– The green indicator light will now flash twice.
If the light flashes once for an extended
period, the code has not been entered
properly or the wrong code has been
entered. Start again from step 2.
6 Point the RU252 at the TV and check that it responds as it should.
– If the TV responds to all of the key commands, the RU252 is ready for
use. Do not forget to note your code.
• If the device does not respond at all, or not to all of the
key commands, start again from step 2 and try the next code
from the list.
RU252.qxd 04-06-2004 16:55 Pagina 5