Filter
Top Products
Automatically setting the remote control
If you cannot find the right code for your brand device, the remote control
can automatically search for the right code.
Example of TV:
1 Make sure the TV is switched on and select a channel using the original
remote control or the keys on the TV (for example channel 1).
The RU252 emits the ‘switch off TV’ signal for all models of TV that are
stored in the memory.
• If the device is a DVD-player or video recorder,
insert a disk or tape and start playback.
2 Then keep keys 1 and 3 on the RU252
pressed simultaneously for three seconds, until
the green indicator light remains lit.
3 Press the Standby key of the RU252 briefly.
– The RU252 now starts emitting all known ‘TV off ’ signals, one by one.
Each time a code is sent, the green indicator
light flashes.
4 When your TV switches off (stand-by),
you press the Standby key of the RU252
twice within 1 second, to confirm.
– The RU252 has now found a code that works
on your TV.
5 Check if you can operate all functions on your TV with the RU252.
• If this is not the case, you can redo the automatic setting.The
RU252 will then search for a code that perhaps works better.
– After the RU252 has run through all the known codes, the search will
stop automatically and the green light will stop flashing.
– Automatic programming of a TV takes a maximum of 8 minutes.
For VCR/DVD this time is 4 minutes.
6
Instructions for use
English
RU252.qxd 04-06-2004 16:55 Pagina 6