Filter
Top Products
ENGLISH
5
The SBC RU865 has six operating modes for operating six different devices.TV,VCR,
DVD and AMP are default device modes.The other 2 can be installed from a choice of
18 devices.To create your personal list of device modes just add and remove devices and
make any combination of six devices from its library.The LCD display shows you which
device mode is activated.To switch between device modes simply press the Select
Device keys.With the programmable SMART CONTROLS any function can be added to
each installed device.
In HOME CINEMA MODE the major functions of TV, DVD and Amplifier are at hand.
Just press the CINEMA key and without the need of changing device mode, basic key
functions of your home cinema devices can be operated.
For more information see chapter 3.‘Home Cinema mode’.
1. Setup
The SBC RU865 is ready to operate most Philips TVs,VCRs, satellite tuners, DVD-players,
CD-players, tuners, amplifiers and home cinema systems. For other brands of equipment,
it first needs to be set up.This only takes a couple of seconds, thanks to Philips' ‘Simple
System Set-up’!
There are two setup modes:
- normal setup mode: to set up basic key functions of each installed device;
- home cinema setup mode: to set up basic key functions of your home cinema system.
Add device
1 Look up the brand name of the device you wish to operate in the code list
(centre of this manual).
2 Switch on the device you wish to add.
3 Press and hold SETUP until SETUP lights up in the display.
➜ DEV (first line)
➜ ADD (second line)
4 Confirm with SEND.
➜ SAT (second line)
5 Use SMART CONTROLS to select the device to be added.
➜ CABLE (for example - second line)
6 Confirm with SEND.
➜ CODE (first line)
7 Use the Numeric keys to enter the code.
➜1234 (for example - second line)
8 Confirm with SEND.
➜ STORED (second line)
9 Press any key to check if the code is correct and your device responds.
If the device does not respond or if not all keys function properly the code is not correct.
In this case see ‘Change device code’ hereafter.
Remove device
1 Press and hold SETUP until SETUP lights up in the display.
➜ DEV (first line)
➜ ADD (second line)
2 Use SMART CONTROLS to select REMOVE.
➜ REMOVE(second line)
3 Confirm with SEND.
➜ TV (second line)
4 Use SMART CONTROLS to select the device to be removed.
➜ VCR (for example - second line)
5 Confirm with SEND.
➜ REMOVED (second line)
Change device code
1 If the entered code is not correct look up the next code in the code list
(centre of this manual).
2 Press and hold SETUP until SETUP lights up in the display.
➜ DEV (first line)
➜ ADD (second line)
3 Use SMART CONTROLS to select CODE.
➜ CODE (second line)
4 Confirm with SEND.
➜ TV (second line)
XP SBC RU 865.1 15-08-2002 10:26 Pagina 5