Filter
Top Products
11
ENGLISH
4. Select the device and brand of the device
you want to add by using the cursor keys.
Press OK. The remote will search the
database for available code sets.
5. Follow the on-screen instructions to test
the codes. When a working code set is
found, your device is correctly installed.
When the device is correctly installed, the
following screen appears:
If no working code set is found:
•Youcanperformafulldatabasesearchto
find a correct code set. This can take up to
25 minutes.
•Youcanlearncodesfromtheoriginal
remote device.
To add an additional device:
1. Select “Yes”, Press OK.
2. Repeat this process for each
additional device.
3. When you are finished adding devices,
select “No”. Press OK. Exit the wizard.
D Note
You can adjust the settings of your universal
remote for iPod™ anytime after initial install
via the set-up menu. Press the MODE and IPOD™
LAUNCH keys simultaneously for 3 seconds.
The screen will ask you to press and hold the 2
keys for 3 seconds to enter set-up mode.
GettingStarted