Filter
Top Products
Automatically setting the remote control
If you cannot find the right code for your brand device, the remote control can automatically search for the
right code.
1 Make sure the TV is switched on and select a channel using the original remote control or the keys on
the TV (for example channel 1).
2 Keep keys 1 and 3 on the SRU 1018 pressed simultaneously for
five seconds, until the indicator light remains lit.
3 Press the y key of the SRU 1018 and keep it pressed.
– The SRU 1018 now starts emitting all known ‘TV off’ signals,one by one.
Each time a code is sent, the indicator light flashes.
4 When your TV switches off (stand-by),immediately release the y key of the
SRU 1018 to confirm.
– The SRU 1018 has now found a code that works on your TV.
5 Check if you can operate all functions on your TV with the SRU 1018.
• If this is not the case, you can redo the automatic setting.
The SRU 1018 will then search for a code that perhaps works better.
– After the SRU 1018 has run through all the known codes,the search will stop automatically and the
indicator light stops flashing.
– Automatic programming of a TV takes a maximum of 6 minutes.
6 ENGLISH