Filter
Top Products
6. Manual recording
EN
Searching for tape position without
picture (forward wind and rewind)
1.
1.Stop the tape with .
2.
2.Press (reverse) or
(forward).
3.
3.To stop the tape, press .
Manual Tracking
To manually adjust the tracking during playback,
press or
.
Tracking will return to Automatic Tracking
Adjustment when you press , insert a
tape, or press .
To remove vertical jitter in a Still picture, press
or .
PROG P–
PROG P+
PROGRAMME
-
PROGRAMME
+
PLAY B-K
STOP C-L
PROG P–
PROG P+
PROGRAMME
-
PROGRAMME
+
STOP C-L
FWD 1- B
REW0- s
STOP C-L
10
General information
Use 'Manual Recording' to make a spontaneous
recording (for example, a programme currently
being shown).
If you want to start and stop a recording manually,
read the section
'Recording without automatic
switch-off'.
If you want to start a recording manually but have
it stopped automatically, read the section
'Recording with automatic switch-off'.(e.g. not
to record to the end of the tape)
Recording without automatic switch-off
1.
1.Insert a cassette.
2.
2.Use to select the pro-
gramme number you want to record, for
example, 'P01'.
3.
3.To start recording, press .
4.
4.Stop recording with .
Recording with automatic switch-off
(OTR One-Touch-Recording)
1.
1.Insert a cassette.
2.
2.Use to select the pro-
gramme number you want to record.
3.
3.Press .
4.
4.Each time you press you will add 30
minutes to the recording time.
5.
5.Stop recording with .
Preventing accidental erasing
All cassettes (except rental and pre-recorded
cassettes) have a security tab on the back of the
cassette.
To prevent recording over important recordings
(erasing), you can remove this security tab.
If you later decide to record on a protected cas-
sette, simply cover the hole with adhesive tape
or slide the tab to the right.
Lining up recordings (assemble cut)
When you add a further recording to a cassette,
which already has a recording on it, a short
blank (flicker) can appear between the old and
the new recording or the picture itself can flicker.
To help reduce these from occurring, proceed as
follows:
1.
1.Find the tape position of the old recording
where you want to insert the new recording.
2.
2.Look at the last minute of the old recording
(playback).
3.
3.Press at the tape position where the
new recording is to go and press .
4.
4.Now start recording as usual by pressing
on the remote control.
5.
5.Stop recording with .
STOP C-L
REC I
REC I
STILL
22
STOP C-L
REC I
REC I
PROG P–PROG P+
STOP C-L
REC I
PROG P–PROG P+
HE271BD(EN).QX3 03.2.21 2:25 PM Page 10