Philips VR140/07 DVR User Manual


 
EN
6.
6.If the connection was properly made and your TV
was automatically switched to the programme
number for the scart socket, you will see the fol-
lowing picture:
Then, read the paragraph 'Preparation for use' in
the chapter 'Installing your video recorder'.
Connecting without a scart cable
Have the following cables ready:
an aerial cable.
1.
1.Switch off your TV.
2.
2.Remove the aerial
cable plug from the
aerial input socket of
the TV. Insert it into
the AERIAL at the
back of the video
recorder.
3.
3.Insert one end of the
supplied aerial cable
into the RF OUT at
the back of the video recorder and the other
end into the aerial input socket at the back of
the TV.
4.
4.Insert AC cable into the wall socket.
5.
5.Switch on your TV and select the programme
number used for video playback on your TV
set (see your TV's operating instructions).
6.
6.Select this programme number and manually
start the TV's channel search as if you want-
ed to save a new TV channel until the next
screen appears.
7.
7.Save this programme number setting on your TV
for video recorder operation.
You can find more details in chapter 'Preparation
for use'.
AERIAL
R
F O
UT
T
V
A
E
RIAL
RF OUT
R
F O
U
T
TV
A
E
R
IA
L
5
Programme number for video recorder opera-
tion
You have now saved a programme number for use
by your video recorder as you would a regular TV
channel.This programme number must now be
used in future for video recorder playback ('video
recorder' TV channel).
My screen is empty
Many TVs are switched to the programme number
for the scart socket by way of a control signal sent
through the scart cable.
If the TV does not automatically switch to the scart
socket programme number, manually change to
the corresponding programme number on your TV
(see your TV's operating instructions).
PLEASE CONNECT AERIAL OR
CABLE TO THE VCR
THEN...
PUSH P+ KEY
OR
FOR PLAY ONLY-PUSH PLAY
PLEASE CONNECT AERIAL OR
CABLE TO THE VCR
THEN...
PUSH P+ KEY
OR
FOR PLAY ONLY-PUSH PLAY
HE271BD(EN).QX3 03.2.21 2:25 PM Page 5