Filter
Top Products
DIf you want to set a later end time for a recording,
press the Pq button. Each time you press the
P q button, you will add 15 minutes to the end time.
f Confirm with the OK button when the information is
correct.
DThe programming information has been stored in a
TIMER block.
g Select the recording speed SP or LP with the
SP/LP, AV button.
h Make sure that the cassette you have put in can be
recorded on.
i Switch off with the TV/STANDBY m button.
The programmed recording will only function when the
video recorder is switched off with the TV/STANDBY m
button.
DIf any of the TIMER blocks are in use, ’k’ will light up
on the video recorder display.
DWhile a programmed recording is being made, you
cannot operate your video recorder manually. If you
want to cancel the programmed recording, press the
TV/STANDBYm button.
DIf the video recorder is switched on a few minutes
before a programmed recording is supposed to
begin, ’TIMER RECORD’ will flash on the TV
screen.
DIf you reach the end of the cassette during a
recording, the video recorder will automatically
eject the cassette.
DIf you forget to load a cassette, ’NO CASSETTE’
will appear on the TV screen and ’k’ will flash on the
video recorder display.
DIf you have put in a cassette which cannot be used
for recording, the video recorder will automatically
eject it.
DIf ’TIMER FULL’ appears on the TV screen when
you press the TIMER button, you have used up all
the available TIMER blocks. If you want to clear or
check a TIMER block, select it with the Pq or
P r button.
DProgramme numbers ’E1’ and ’E2’ are for
recordings from other sources (through scart socket
EXT.1 AV 1 or EXT.2AV 2 ).
Programming a recording
(without ’VIDEO Plus+’)
a Switch on the TV set and select the programme number
for the video recorder.
b Press the TIMER button on the remote control twice .
c Select a free TIMER block with the Pq or Pr button.
Press the TIMER button.
DATE PROG START V/P END
01 01 20:00 21:30
------------------------
NEXT gTIMER CLEAR gCL
-/+ 0-9 D/WgSELECT OK
d With the TIMER , C/Sq or D/Sr button you
can select ’DATE’ (date), ’PROG’ (programme number),
’START’ (start time) and ’END’ (end time).
Enter or change your information with the Pq or
P r button, or with the number buttons 0-9 .
DUnder ’DATE’, use the SELECT button to select daily
or weekly programming.
’D’: Recording from Monday to Friday.
’W’: Recordings every week on the same day.
DUnder ’START’, use the SELECT button to switch
’VPS or PDC’ on or off.
e Confirm with the OK button when the information is
correct.
DThe programming information has been stored in a
TIMER block.
f Make sure that the cassette you have put in can be
recorded on.
DUse the SP/LP, AV button to select the recording
speed ’SP’ or ’LP’.
g Switch off with the TV/STANDBY m button.
The programmed recording will only function when the
video recorder is switched off with the TV/STANDBY m
button.
DIf any of the TIMER blocks are in use, ’k’ will light up
on the video recorder display.
16