Filter
Top Products
13
Manual TV channel search
In some cases it could occur that all of the TV channels were not found and saved during the
initial installation. In this case, the missing or coded TV channels must be searched for and
stored manually.
1 Switch on the TV set. If required, select the programme number for
the video recorder.
2 Press MENU on the remote control. 'CLK' will appear in the display.
3 Using P =r or P ;q , select 'MAN' in the display (manual channel
search).
4 Press OK .
5 Using P =r or P ;q , select the desired programme number that
you want to use for the TV channel, e.g. 'P01' and confirm with OK .
6 Select the desired display using P =r :
What is hidden behind the settings?
'CH': Display/Entry of channels
'S-CH': Display/Entry of special channels
7 Confirm with OK .
'CH' will flash in the video recorder display.
a'CA' will flash in the display instead of 'CH'
b It will be switched to the display/entry of special channels. If you do not
want to assign a special channel, press MENU and begin again at step
4 .
8 Enter the channel of the desired TV station using the number buttons
0-9 .
aI don't know the channels for my TV stations
b In this case, press P ;q to start the automatic channel search. A changing
channel number will appear in the video recorder display.
Continue the automatic search until you have found the desired TV
channel.
9 To save the TV channel, press OK as often as necessary until 'OK'
appears in the display.
0 To search for other TV channels, begin again at step
4 .
A To end, press MENU .
ENGLISH
Installing your video recording