Filter
Top Products
42
42
OPTIMIZING THE MODULATOR ENGLISH
OOppttiimmiizziinngg tthhee mmoodduullaattoorr
If the TV set and the video recorder are only connected with an
aerial cable - rather than with an additional scart cable - it may
happen that in certain reception locations the modulator
frequency of the video recorder is occupied by a TV channel.
Result: As soon as the video recorder is switched on, the
reception quality of the TV picture deteriorates. The following
steps will show you how to overcome this problem.
SSuupppprreessssiinngg iinntteerrffeerreennccee
11
11
TTIIPP
WWhhaatt iiss aa mmoodduullaattoorr??
The purpose of this electronic assembly inside your
video recorder is to pass on the picture and sound
information read in from the video tape via an aerial
cable like a TV signal to the TV set. The modulator
frequency determines the frequency range in which
these signals are transmitted.
1 Switch the video recorder on and make sure
there is no cassette in the video recorder
3 The video recorder will now transmit a test
image on this frequency
2 Press at the same time the
SSTTOOPP
button
hh
on the remote control and the
SSTTOOPP//EEJJEECCTT
button
JJ
on the front of the video recorder
until the modulator frequency of the set
appears in the display (e.g.: M583 for 583
MHz)
4 Use
==PP--
or
;;PP++
to select the option
OPTIMIZE FREQUENCY and enter a new
frequency with the number buttons
00--99
PPRROOBBLLEEMM
WWhhiicchh mmoodduullaattoorr ffrreeqquueennccyy sshhoouulldd II eenntteerr??
You can also make the video recorder search
automatically for an appropriate frequency. To do so,
simply hold down the buttons
SS++ PP
.As soon as a
free frequency has been found, it will be shown in the
display.
5 Tune the programme number of your TV set
allocated for video use to the new modulator
frequency until you see the test image
sharply and in colour
M583
OPTIMIZE MODULATOR
OPTIMIZE FREQUENCY
Q583P
MODULATOR ON
EXITPMENU STOREPOK
?