Filter
Top Products
Selecting a cross-over frequency
You can select a frequency, under which
sounds are reproduced through the subwoo-
fer. If the installed speakers include one whose
size has been set to Small, you can select a
frequency, under which sounds are repro-
duced through a Large speaker or subwoofer.
1 Touch Cross Over.
2 Touch a or b to select the speaker to
be adjusted.
Each time you touch a or b selects the speak-
er in the following order:
Front (front speakers)—Center (center speak-
er)—Rear (rear speakers)—Subwoofer (sub-
woofer)
3 Touch c or d to select cross-over fre-
quency.
Each time you touch c or d selects cross-over
frequencies in the following order:
63Hz—80Hz—100Hz—125Hz—160Hz—
200Hz
Note
Selecting a cross-over frequencyis to set a cross-
over frequency of the subwoofer’s L.P.F.(low-pass
filter) and that of the Small speaker H.P.F.(high-
pass filter). The cross-over frequencysetting has
no effect if the subwoofer is set to Off and other
speakers are set to Large or Off.
Adjusting the speaker output
levels using a test tone
This function allows you to easily get the over-
all balance right among the speakers.
1 Touch Test Tone.
2 Touch Start to start the test tone out-
put.
The test tone is outputted. It rotates from
speaker to speaker in the following sequence
at intervals of about two seconds. The current
settings for the speaker over which you hear
the test tone are shown in the display.
Front-L (front speaker left)—Center (center
speaker)—Front-R (front speaker right)—
Rear-R (rear speaker right)—Rear-L (rear
speaker left)—Subwoofer (subwoofer)
Check each speaker output level. If no adjust-
ments are needed, perform step 4 to stop the
test tone.
# The settings do not appear forspeakers
whose size is set to Off. (Refer to Setting the
speaker setting on page 87.)
3 Touch c or d to adjust the speaker out-
put level.
Each time you touch c or d it increases or de-
creases the equalizer level. +10 to –10 is dis-
played as the level is increased or decreased.
# The test tone rotates to the next speaker after
about two seconds from the last operation.
4 Touch Stop to stop the test tone out-
put.
Notes
! If needed, select speakers andadjust their ‘ab-
solute’ output levels. (Refer to Adjusting the
speaker output levels on the previous page.)
! To adjust the speaker output levels in this
mode is the same as making the speaker out-
put levels at Speaker Level (speaker output
level). Both provide the same results.
Using the time alignment
The time alignment lets you adjust the dis-
tance between each speaker and the listening
position.
1 Touch Time Alignment.
2 Touch any of the following touch panel
keys to select the time alignment.
! Initial – Initial time alignment (factory set-
ting)
Available accessories
En
89
Section
19
Available accessories