Filter
Top Products
— When delays occur for low sounds due
to the influence of the LPFon active
subwoofers or external amps.
! Auto TA and EQ changes the audio settings
as below:
— The fader/balance settings return to the
center position. (Refer to page 85.)
— The equalizer curve switches to Flat.
(Refer to page 90.)
— It will be adjusted automatically to high
pass filter setting for front, center and
rear speaker.
! If you carry out auto TA and EQ when a pre-
vious setting of this already exists, the set-
ting will be replaced.
Carrying out auto TA and EQ
1 Stop the car in a place that is as quiet
as possible, close all doors, windows and
the sun roof, and then turn the engine off.
If the engine is left running, engine noise may
prevent correct auto TA and EQ.
2 Fix the supplied microphone in the cen-
ter of the headrest of the driver’s seat, fa-
cing forward, using the belt (sold
separately).
The auto TA and EQ may differ depending on
where you place the microphone. If desired,
place the microphone on the front passenger
seat to carry out auto TA and EQ.
3 Turn the ignition switch to ON or ACC.
If the car’s air conditioner or heater is turned
on, turn it off. Noise from the fan in the air
conditioner or heater may prevent correct auto
TA and EQ.
# Press SRC/OFF to turn the source on if this
unit is turned off.
4 Select the position for the seat on
which the microphone is placed.
Refer to Using the position selector on page
84.
# If no position is selected before you start auto
TA and EQ, Front-L is selected automatically.
5 Touch the source icon and then touch
Off to turn this unit off.
6 Touch the screen to display the touch
panel keys.
7 Touch AV Menu and then touch
Initial Menu to display the function names.
8 Touch Auto EQ&TA to enter the auto TA
and EQ measurement mode.
9 Plug the microphone into the micro-
phone input jack on the multi-channel pro-
cessor.
For details concerning operation, refer to the
multi-channel processor’s operation manual.
10 Touch Start to start the auto TA and EQ.
Available accessories
En
93
Section
19
Available accessories