Filter
Top Products
78
En
Caution: Connecting Information
The Analog copy protect technology is copy guarded.
If the player is connected to a TV via a VCR, or if files
are recorded/played back through a VCR, the picture
may have distortions.
Connecting the PlayerHow to Display Total
Hours Played and
Power ON Time
DVD.
I
Video CD
.
I
CD .
The DVD-V7400 displays the total play time and power ON
time to provide working condition and maintenance timing
information.
Refer to the directions below to display the play time and
power ON time.
1 Press and hold
DISPLAY
on the player's front
panel before turning the power ON,
press
STANDBY
ON
2 Verify that the screen shows the following:
3 When performing an operation such as
playback from the remote control, time
information disappears as normal operation
begins.
NOTE
÷
Because time is measured by the CPU clock, information
includes an error of up to two percent.
÷
Changing the total play time and power ON time to zero is
unavailable.
OPERATING TIME
POWER ON 00105:46
PLAY 00078:13
Total play time is 78 hours,
13 munites for this
example
Power ON time is 105
hours, 46 minutes for
this example
Right
Left
✩
✩
✩
÷
Connect plugs to the terminals that match the plug’s color
(white, red, yellow).
÷
Align the plug with the connector and insert smoothly
then tighten the lock screws.
÷
Align the plug properly with the tab on the connector and
press in carefully. Rotate the plug to the right to lock.
✩ Cables can be found at local audio/video dealers
÷
Connect the TV's S-VIDEO terminal to theplayer's
S-VIDEO output terminal.
screw
Video Output
Audio Output
Interface Connector (RS-232C)
S-video Output
External Sync Input (BNC)/Video Output (BNC)/
Component Video Output (BNC)