Filter
Top Products
The Initial Setup menu
111
En
14
Colour RGB (0–255)
Use if colours are weak and black appears to ‘float’
on the
RGB (16–235)
setting.
RGB (16–235)
Use this setting if colours appear overly rich and the
black too deep on the
RGB (0–255)
setting.
YCbCr 4:2:2
The video signal is output as a 10-bit YCbCr 4:2:2
component signal. This is the standard setting for
HDMI-compatible devices.
YCbCr 4:4:4
The video signal is output as a 8-bit YCbCr 4:4:4
component signal.
• Depending on the connected device some settings may not be available.
• When a DVI device is connected, the
YCbCr 4:2:2
and
YCbCr 4:4:4
options are not available.
• You cannot choose
YCbCr 4:2:2
when the
Screen Resolution
is set to
720 x 480i
.
Audio Output Auto •
Dolby Digital, MPEG and DTS sources are output as a
bitstream signal. However, depending on the
Audio
Out
setting, number of audio channels, and the HDMI-
connected device, Linear PCM audio may be output.
PCM
All audio signals are converted to Linear PCM (except
DTS).
Bitstream Priority
Select if the connected device is compatible with
bitstream audio.
This setting is not available when a DVI device is connected
.
Options
On Screen Display On •
The recorder displays operation displays (
Stop
,
Play
,
etc.) on-screen.
Off
Switches off the on-screen operation displays.
Front Panel Display On •
The time is shown in the front panel display when the
recorder is in standby.
Off
The front panel display is switched off in standby.
Remote Control
Mode
Recorder 1–3
(default: Recorder 1)
If you are using more than one recorder in the same
room, set them to different IDs. This setting sets the
recorder ID; to change the remote controller ID, press
and hold
RETURN
then press
1
,
2
or
3
to set. The
remote will only control a recorder with the same ID.
DivX VOD Registration Code
Use to display the recorder’s DivX registration code.
See
DivX video compatibility
on page 11 and
DivX®
VOD content
on page 12.
Setting
Options Explanation
DVR650HK_KC_EN.book 111 ページ ２００７年２月２１日 水曜日 午後４時３１分