Filter
Top Products
Additional information
12
49
En
English
If the following error codes appear on the screen, check the corresponding items in the table.
Signal assignments for 15-pin D-sub connector
Standard channel allocation selections for countries and regions
• POWER ON indicator or STANDBY indicator
is quickly flashing.
• Internal protective circuits may have been activated. First turn the main power off by pressing POWER on the
plasma display, and then turn the power on again in after one minute or more.
• If the problem is not solved with this, contact a Pioneer Service Center or Pioneer Authorized Independent Service
company. These are listed on your warranty card for each country or region.
Code Message Check
SD04 and SD11 Powering off. Internal temperature too high.
Check temperature around PDP.
Check if the ambient temperature of the plasma display is high.
SD05 PDP-507XG
Internal protection circuit turns power off.
Is there a short in the speaker cable?
PDP-427XG
Internal protection circuit turns power off.
Check the speaker cable connections between the plasma display and
the speakers.
Contact a Pioneer Service Center or Pioneer Authorized Independent
Service company. These are listed on your warranty card for each
country or region.
Problem Possible solution
Pin No. Signal assignment Pin No. Signal assignment
1 R 9 +5 V
2 G 10 GND (ground)
3 B 11 Not connected
4 Not connected 12 SDA
5 Not connected 13 HD
6 GND (ground) 14 VD
7 GND (ground) 15 SCL
8 GND (ground)
Region Standard channel allocation Region Standard channel allocation
Taiwan Cable (US Type) Lebanon Normal
Hong Kong Normal United Arab Emirates Normal
Philippines Cable (US Type) Mexico Cable (US Type)
Thailand Normal Chile Cable (US Type)
Malaysia Normal Brazil Cable (US Type)
Singapore Normal Australia Normal
Indonesia Normal New Zealand Normal
Saudi Arabia Normal Egypt Normal
Israel Normal South Africa Normal