Pioneer RS-232 Flat Panel Television User Manual


 
3
RS-232C Adjustment Mode
1.2 Interface
1) Connector
D-sub 9 pins (male)
2) Pin layout
3) Baud Rate
9600 bps (standard)
(switch-able to 1200, 2400, 4800, 19200, 38400 bps)
Note
The panel's baud rate should be set to match the computer's baud rate.
Also, when extending the RS-232C cable over a long distance, lower the baud rate.
4) Data format
Start: 1 bit
Data: 8 bit
Parity: 0 (no parity)
Stop: 1 bit
5) Connection
6) Protocol
From the computer to the display
Straight Cable
* D-sub 9-pin/D-sub 25-pin conversion tables are now available on the market.
2
2
3
2
3
2
RXD 3 2 TXD RXD 2 2 TXD
TXD 2 3 RXD TXD 3 3 RXD
CTS 5 8 RTS CTS 8 8 RTS
GND 7 5 GND GND 5 5 GND
5
96
1
Pin No.
Signal
1 NC (not connected)
2 TxD (Transmit Data)
3 RxD (Receive Data)
4 NC (not connected)
5 GND
Pin No.
Signal
6 NC (not connected)
7 NC (not connected)
8 RTS (Request To Send)
9 NC (not connected)
(1) When sending one command at a time:
STX (02 hex) ID (2 Byte) COMMAND (3 Byte or 6 Byte) ETX (03 hex)
(2) When numerical direct commands are possible:
STX (02 hex) ID (2 Byte) COMMAND (3 Byte) ARGUMENT (3 Byte) ETX (03 hex)
COMMAND: 3 Byte (ASCII)
ARGUMERNT: 3 Byte (ASCII)
(3) Echo back
STX (02 hex) COMMAND (3 Byte or 6 Byte) ETX (03 hex)
When the received command is a numerical direct effect command, numerical data is returned.
STX (02 hex) COMMAND (3 Byte) ARGUMENT (3 Byte) ETX (03 hex)
When the received command is invalid, ‘ERR’ is returned.
STX (02 hex) ERR (3 Byte) ETX (03 hex)
When the received command cannot be processed (when PON is received, when the power
is already ON, etc.), ‘XXX’ is returned.
STX (02 hex) XXX (3 Byte) ETX (03 hex)
Control PC
(with D25 serial port )
Plasma Display
(PDP-505CMX/50MXE10/50MXE11)
(PDP-504CMX/50MXE1/50MXE1-S)
(PDP-434CMX/43MXE1/43MXE1-S)
Control PC
(with D9 serial port)
(with D9 serial port)
Plasma Display
(PDP-505CMX/50MXE10/50MXE11)
(PDP-504CMX/50MXE1/50MXE1-S)
(PDP-434CMX/43MXE1/43MXE1-S)