Filter
Top Products
Getting started04
42
En
Using the wireless speaker
system
The wireless speaker supplied with your
system can be used for multichannel sound
with your main setup, or as a second stereo
speaker system.
1 Switch the wireless speaker off and the
main unit into standby.
2 Press SYSTEM SETUP.
3 If it’s not already selected, use
/
(cursor left/right) to select ‘Wireless?’ then
press
ENTER.
The current setting is shown in the display.
4 Use
/
(cursor up/down) to select
‘W.Surr.’ or ‘W.Stereo’ then press ENTER.
•
W.Surr.
– Sounds going to the surround
left and right channels are heard through
the wireless speaker (see below for
placement options).
•
W.Stereo
– Any source playing through
the main system is heard in stereo through
the wireless speaker (multichannel
sources will be downmixed to stereo).
5 Set the WIRELESS MODE switch on the
wireless speaker to the same mode you
selected above.
• If the mode of the wireless speaker and the
DVD receiver don’t match, loud noise may
be output from the wireless speaker.
6 Switch the main unit and wireless
speaker back on.
If you selected
W.Stereo
, start playback and
adjust the
STEREO MODE VOLUME
control as
necessary.
If you selected
W.Surr.
continue to the next
step.
7 Press WIRELESS repeatedly to select a
wireless listening mode.
Choose between the following options:
•
Normal
– Use for surround sound with the
wireless speaker placed behind the
listening position.
STANDBY/ON
SYSTEM SETUP
ENTER
WIRELESS
SHIFT
W.SURROUND
W.STEREO
STEREO MODE
VOLUME
MIN
MAX
POWER
OFF
ON
WIRELESS
MODE
Front left
Listening position (main room)
Listening position
(sub room)
Wireless
speaker
Center
Subwoofer
Front right
Front left
Listening position
Wireless speaker
Center
Subwoofer
Front right
XV-DV9.book 42 ページ ２００４年２月２０日 金曜日 午前１１時４２分