Filter
Top Products
Appendix D Plasmon D875 - D2175 User Manual
Page 72 Document Revision E
5 Checking a SCSI posi-
tion to drive command
32 1 Drive not con-
nected
Drive not connected
that was previously
installed
Drive inter-
face cables
Replace or reconnect drive
cables
2 Drive not connected
when restoring drives
33 1 Drive clamp fail Drive clamp fail while
loading drive
Drive, drive
cables
Replace drive or cabling
34 1 Drive unclamp
fail
Drive unclamp fail
unloading drive retry
Drive, drive
cables
Replace drive or cabling
35 1 Drive load fail Tray not seen in picker
while picker moving to
load position
MTE sensor Replace MTE
2 VP or Tray sensor
blocked after retracting
picker to fwd position
MTE sensor,
VP sensor
Replace MTE, VP sensor, run
offsets to correct positioning
3 Drive not set to loaded
4 Drive load retry aborted
36 1 Drive unload fail Drive not unclamped Drive, drive
cables
Replace drives or cables
2 Pick finger did not hold
on to tray, VP or Tray
sensor blocked
Alignment
problem
Run offsets
3 No tray seen in unload
attempt
Alignment
problem,
MTE tray
sensor
Run offsets, replace MTE
4 Picker Tray sensor
blocked during tray only
check of drive unload
Alignment
problem,
MTE tray
sensor
Run offsets, replace MTE
5 Picker Tray sensor
unblocked during tray
only check of drive
unload
Alignment
problem,
MTE tray
sensor
Run offsets, replace MTE
37 1 Drive is clamped Drive is clamped, can't
unclamp (checking
move from a drive)
Drive, drive
cables
Replace Drive, drive cables
Error
Code
(hex)
Sub-
code
Error
Description
Subcode
Description
Compo-
nent
Corrective Action