Filter
Top Products
Plasmon D875 - D2175 User Manual Appendix D
Document Revision E Page 73
2 Drive is clamped, can
not unclamp (checking
move to a drive)
Drive, drive
cables
Replace Drive, drive cables
38 1 Drive in service
state
In service state,
attempting to turn drive
off in maint menu
Follow operating instructions
2 In service state,
attempting to turn drive
on in maint menu
3 In service state,
attempting to put drive
in service state via
SCSI command
39 1 Drive not in ser-
vice state
Restoring drives, not in
a service state
Follow operating instructions
3F 1 Drive Addr con-
flict
Address conflict with
changer
Correct address in setup con-
figuration
2 Address conflict with
another drive
40 1 Not supported
by bus config.
Attempt to put drive in
service state via SCSI,
drive not supported by
current bus config.
2 Attempt to restore drive
via SCSI, drive not sup-
ported by current bus
config.
41 1 Drives overheat-
ing
Warning for an over
heating drive
Cabinet
Temp
Check room temp
42 1 Drives shut-
down - heat
Drive will be shutdown
due to overtemp condi-
tion, alert host of 90 sec
delay before shutdown
Cabinet
Temp
Check room temp
43 1 Low fan speed-
drive
Warning for low fan
speed in a drive module
Fan Replace fan
44 1 Drive shutdown-
fan
Drive will be shutdown
due to fan failure, alert
host of 90 sec delay
before shutdown
Fan Replace fan
Error
Code
(hex)
Sub-
code
Error
Description
Subcode
Description
Compo-
nent
Corrective Action