Filter
Top Products
10
INSTALLATION
1. Remove the LCD TV from the box and place it on a flat surface in a well-ventilated location.
2. Connect the output terminal of RF cable to the corresponding TV RF signal input terminal.
The LCD TV is a high technology digital product, use quality RF cables to obtain optimal
results.
3. Connect the output terminal of the AV devices such as DVD player, VCR, etc. to the
corresponding terminal of your LCD TV.
4. Connect one end of the D-sub terminal to the corresponding terminal of the host computer,
and connect the other end to the corresponding LCD TV terminal. Screw down the screws
on both sides to secure it.
Caution:
When connecting, plug directly and lightly to the interface, otherwise you may
damage the pins in the connector.
5. Ensure that every AV signal cord is correctly connected to the corresponding jack.
6. Put the DC power plug in the DC input outlet of the TV, then plug the AC power plug of the
power adapter in the AC power outlet.
7. The panel can be tilted upwards up to 10
0
to achieve better viewing angle. When doing so,
rotate the TV with two hands, one to hold the pedestal, the other to tilt the panel. Take care to
do this with moderate pressure to prevent damage to the TV.
GENERAL OPERATION
To Turn the TV On
After the power cord is plugged into the power socket, the TV will enter Standby mode.
Press on the remote control or the front panel to turn the TV on
To Turn the TV Off
1. Press on the remote control or the front panel to turn the TV off.
2. Unplug the DC power adapter from the AC wall outlet and then unplug the power adapter
from the TV to turn the set off completely.
Caution: The TV will be shut off automatically when AC power is interrupted. Unplug the
power adapter from the AC outlet if this happens. The last used TV mode will
appear when power resumes.
Do not turn the TV on/off too often.
Unplug the power adapter from the AC outlet if power is suddenly interrupted.