Filter
Top Products
ENGLISH
21
Chapter 3 Using the LCD TV
Chapter 3
USING THE FEATURES
Tuning in the TV channels
After connecting an aerial to your LCD TV and connecting the mains cable to the TV and
230VAC mains socket, turn the POWER SWITCH of rear TV on, a red light will show on the
front centre panel of the TV.
Press the POWER button, the red light will change to green and the First Time Installation
screen will show:
1. Make sure an aerial is tted then press OK button on the remote to start the Auto
Programme Scan (APS).
2.In a short while you will see the TV programmes brie y as each channel is received and
stored in the memory. When APS is completed BBC1 digital TV will show, press CH+/-
buttons to view the other channels stored.When nished ATV scan.TV will Auto change to DTV
do the rst installation channel. To view analogue TV press INPUT button and
use the up / down arrow buttons to select TV and then Press the OK button.Change
channels by pressing the CH +/- buttons.
To power o press the POWER button, the green light will change to red.
Selecting a INPUT
Press the INPUT button to display the function required (TV/AV).Using the arrow buttons
on the remote highlight the function required and press the OK button to select the function.
Select TV Channel
Press the CH.+/- button on the remote control and the CH.+/-button on the LCD TV to change
the TV channels.
You can directly select the TV channel required by pressing 1,2 or 3 etc on the remote
button pad.
Adjusting the Volume
Press the VOL. +/– button on the remote control or the VOL. +/- button on the LCD TV to adjust
the volume.
To Mute the Sound
Press MUTE and the sound cuts o .
To turn mute o , press the MUTE button again, or simply press the VOL +/- button.
Sleep Timer
Press the SLEEP button continuously to select the sleep timer or turn the sleep timer from the
OFF,15,30,60minutes; when the LCD TV has reached the set time, it will automatically turn o . If
the TV has no input signal, it will automatically power down to standby after 15 minutes.