Filter
Top Products
- 19 -
TV Function
Auto Memory
Use the ▼、▲ buttons to select Auto Memory, press the ENT button to enter auto
memory mode:
The auto memory will take a few minutes. The unit will search channels from the
lowest channel to the highest channel in the standard channel list. When tuning
operations are complete the unit will exit and store the channels by sequence in the
memory.
During tuning, press the ◄ button to exit the auto memory.
Use the ▼、▲ direction buttons to select the desired channel from those in memory.
Timer Setup
Press the SET button on the remote control to enter Timer setup menu, the screen will
display as below:
Use the ▼、▲ buttons to select the item you want to set.
Use the ►, ◄ buttons to enter the item and to select.
Press the SET button again on the remote control to exit the setup menu.
Timer
Use the ►, ◄ direction buttons to select ON or OFF. This function allows you to set
the start time and end time of the desired signal source. No matter what mode the unit
is in, it will automatically start the playback of the desired signal source.
Select ON to activate the function; select OFF to disable the function.
TIMER SET
TIMER OFF
POWER ON _ _: _ _ am
POWER OFF _ _: _ _ am
SIGNAL CATV
CHANNEL 002
Exit: SET
SEARCHING CH：009
EXIT：
◄