Filter
Top Products
Installation Instructions Page 11
Securing the Mounting Brackets
Dimples
M4
M5
M6
M8
The Griplate™ have M4, M5 M6 and M8 hole patterns to fit the hardware that your flat
panel requires.
EXAMPLE: If your plasma uses M8 x 20 Phillip screws, use the M8 mounting
points.
Step 1. Pre-install the four (4) quick release pins to desired height setting (see illustration above).
The dimples of the top plates have to be facing up and the bottom dimples must be facing down.
Do not over tighten the mounting hardware.
Step 2. Once the mounting brackets are aligned secure the Griplate™ to the flat panel.
The quick release pins will be used to adjust the mounting arms. The display must be kept, at a minimum, 1/4”
from the plexiglass front. This distance will allow the 6800 Enclosure Series to properly ventilate. There will be no
overheating as long as this distance is kept permanent.
QUICK RELEASE
PI
N
Phillips Head Screwdriver
DIMPLES
FACING UP
DIMPLES
FACING UP
DIMPLES
FACING DOWN
DIMPLES
FACING DOW
N
GB-ENCL42