Filter
Top Products
Page 8 Installation Instructions
Proper installation procedure by qualifi ed personnel as outlined in the installation instructions must be adhered to. Failure to do
so could result in serious personal injury and possible damage to the fl at panel.
Determining the Center of the Display
Step 1. Once the flat panel is inverted, use a measuring tape to find the center of your flat panel measuring from outside to outside of
the chassis.
Turn the fl at panel over and place it on a soft, fl at surface to prevent damage to the fl at panel. Use a blanket, foam, etc. Failure
to do so will result in damaging the fl at panel. Do not lay the fl at panel on the fl oor without any protection to the glass. The fl at
panel is heavy and fragile. At least (3) qualifi ed personnel are strongly recommended for installation of this product. Failure to
do so could result in serious injury and possible damage to the fl at panel.
Step 2. Using a pencil lightly mark the center of your flat panel.
Tape
Measure
Inverted
Flat Panel
Bottom of
Flat Panel
C
L
Top of
Flat Panel
Inverted
Flat Panel
Marking the Center
of the Flat Pane
l
L
C
GB-ENCL42