Filter
Top Products
PSD-BW/L
Page - 5 - Installation Instructions
BW Base Castor Installation (Figure 1)
Unpack the PSD-BW/L Nesting Cart and review any WARNING statements that apply to the installation.
Select the desired location for the PSD-BW/L Nesting Cart.
Figure 1
1. Place the BW/L on a flat surface.
NOTE
: Make sure the locking castors (Qty 2) are attached to the rear legs of the Nesting Cart.
2. Insert each castor into the threaded mounting point located on the underside of the BW/L base (Figure 1). Turn each castor
clockwise to tighten. Make sure all four castors are tightened all the way until flush with the base. Tighten using the 21mm caster
wrench (supplied).
Support Tube Installation (Figure 2)
1. Place the BW/L on a flat surface.
2. Take the support tubes and slide them over the mounting clamps that are located on the Nesting Cart.
NOTE
: To perform the following step, the access holes that are located at the end of the support tubes must line up with the
set screw holes on the mounting clamps. The upper access holes will be used for cable management once the display
has been mounted to the support tubes.
3. Insert the set screws into each hole and tighten using the supplied M5 Allen Wrench (Figure 2).
Figure 2
Locking Castor
Non-Locking Castor
Support Tubes
PSD-BW/L Base
M5 Allen Wrench
M10 x 35mm Set
Screw
Access Holes
Mounting Clamps