Filter
Top Products
Installation Instructions Page 11
Cable Management
WMK-027
Electronic Components
Electronic
Components
Cables
Cables
WMK-027
WMK-027
Cable Opening
Cable Opening
Projector Hook-Ups
Projector Hook-Ups
Electronic Components
Cable Opening
Step 1. The cable access holes are located at the end of the short throw mount and on the wall plate.
Step 2. Route the cables through one end of the WMK-027 and out the other end.
Set Screw Installation (Optional)
The M6 set screw will be used in conjunction with any
standard 1-1/2” NPT or CLS (sold separately).
Step 1. Thread in CLS or any 1-1/2” NPT until
securely fastened.
Step 2. Thread in one (1) M6 x 6mm set screw.
Step 3. Use an M3 security wrench to tighten the M6
set screw (included in the PDS-PLUS
hardware).
Upper Mounting
Bracket
M6 Set Screw
M3 Security
Wrench