Filter
Top Products
Page 6 Installation Instructions
Solid Surface Installation
Concrete drill bits are commercially available.
Step 1. Place the wall plate against
the wall and use a level to
make sure the wall plate is
level from top to bottom.
Step 2. Use a pencil to mark the
location of the mounting
holes.
Step 3. Use a 3/8” drill bit to drill the
mounting holes where the
marks were made with a
pencil.
Step 4. Once the holes have been
drilled, place the concrete
wedge anchors into the
hole. Using a hammer,
gently tap into place.
Step 5. Once the wedge anchors
have been inserted into the
mounting holes, remove the
nut and at washer from the
wedge anchor.
Marking
Drill
Pilot Hole
Hammer
Wedge Anchor
3/8” Drill Bit
Step 6. Place the wall plate over the
wedge anchors once the
wedge anchors have been
correctly inserted into the
mounting surface.
Step 7. Place the at washer and
nut onto the wedge anchor
and tighten using a socket
and socket wrench. Do not
overtighten.
Step 8. Insert and gently tap the wall
plate covers into place.
Completed Installation
Seated Wedge
Anchor
Wall Plate
Socket
Wall Plate
Nut and Washer
Wall Plate
Covers
WMK-027