Filter
Top Products
15
OPERATION
VOL BASS TRE MID BAL FAD
(Volume) (Bass) (Treble) (Middle) (Balance) (Fader)
BASIC OPERATION
SWITCHING ON/OFF THE UNIT AND
ILLUMINATING
Press PWR/ILL button on the front
panel or POWER/ILL button on the
remote control to turn on the unit. When
system is on,press PWR/ILL or
POWER/ILL button shortly to control the
brightness of VFD. Press the button for
several seconds to turn off the unit.
FACEPLATE RELEASE
Press OPEN button on the front panel to
detach the removable faceplate.
SOUND ADJUSTMENT
Press SEL button on the front panel of
the unit or on the remote control to select
the desired adjustment mode.
The adjustment mode will change in the
following order:
By pressing the VOL+/- buttons on the
front panel or VOLUME +/- buttons on
the remote control, it is possible to adjust
the desired sound quality.
SET THE CLOCK
Press the DISP button on the front panel
or DISPLAY button on the remote control,
the clock is shown on the display. Then
hold down the DISP button or DISPLAY
button until the clock flashes. Then press
button on the front panel or button
on the remote control to change minutes;
press
on the front panel or button
on the remote control to change hours.
MUTE
Press and hold MUT/ENT button on the
front panel for several seconds or press
MUTE button on the remote control to
mute down the sound instantly. Press it
again to resume sound output.
EQUALIZATION
Press EQ button on the remote control to
turn on equalization function and to select
desired audio mode. There are five kinds
of mode as below:
SUBWOOFER
Press MODE (SW) button on the front
panel or on the remote control for several
seconds to toggle sub-woofer output.
Press it for several seconds again to
release this mode.
MODE SELECTION
Press MODE button on the front panel of
the unit or MODE button on the remote
control to select among radio, disc
(DVD/VCD/CD/MP3) play mode, CDC
mode and AV IN mode.
VACUUM FLUORESCENT DISPLAY
Exhibit current frequency and activated
functions on the display of the front
panel.
FLASHING LED
If the front panel does not install in the
main unit, the LED will be flashing.
REMOTE SENSOR
Point the remote control handset to the
remote sensor IR. Press the function
keys on the handset to control the
system.
RESET FUNCTION
RESET button must be activated with
either a ballpoint pen or thin metal object.
The RESET button is to be activated for
the following reasons:
- Initial installation of the unit when all
wiring is completed.
- All the function buttons do not operate.
- Error symbol on the display.
Note: if press RESET button, the unit
can’t work yet, please use a cotton swab
soaked in isopropyl alcohol to clean the
socket on the front panel.
FLAT CLAS POP ROCK DSP OFF