Filter
Top Products
5–Customer Replaceable Units
Replacing Transceivers and Stacking Cables
59229-05 A 5-3
Replacing Transceivers and Stacking Cables
The transceivers and stacking cables can be removed and replaced while the
switch is operating without damaging the switch or the transceiver. However,
transmission on the affected port will be interrupted until the transceiver is
installed and reconnected. To remove a transceiver, pull on the release tab or
lever and remove the transceiver. Different transceiver manufacturers have
different release mechanisms. Consult the documentation for your transceiver. To
install, insert the transceiver into the port and gently press until it snaps in place.
The transceiver will fit only one way. If the transceiver does not install under gentle
pressure, flip it over and try again.
¡PRECAUCIÓN!
Para evitar un calentamiento excesivo, todas las placas y paneles vacíos
deben estar en su sitio para proporcionar una refrigeración adecuada.