Filter
Top Products
4-IN-ONE REMOTE POWERED BY KAMELEON
14 Clearing All Programming
2. Using the number keys, enter 9 8 0. The
IR segment will flash twice, pause, and
flash twice again to confirm that all
custom programming is cleared.
CLEARING ALL
PROGRAMMING
The RadioShack 4-in-One Remote contains a
Programming Reset program. You can use it
to remove all custom programming,
including your setup codes and reassigned
device keys.
IMPORTANT: Executing this program will
erase all custom settings for Volume Lock
and Favorite Channels. It will also erase
any device codes or reassigned modes.
1. Press and hold P until the IR segment
flashes twice.
2. Using the number keys, enter 9 8 1. The
IR segment will flash twice, pause, and
flash twice again to confirm that all
custom programming is cleared.
TROUBLESHOOTING
PROBLEM: No display at all times.
SOLUTION: Replace batteries with four
new AA alkaline batteries.
PROBLEM: No display when
programming.
SOLUTION: Display has turned off due
to inactivity. Start
programming again and do
not pause while performing
instructions.
PROBLEM: During programming, the
IR segment displays a long
flash.
SOLUTION: An invalid entry has
occurred. Check the keys to
be pressed and start
program again.
PROBLEM: The unit does not control
home entertainment
devices or commands are
not working properly.
SOLUTION: Try all listed codes for the
device brands being set up.
Make sure they can be
operated with an infrared
remote control.
PROBLEM: Favorite channel function
does not work properly.
SOLUTION: Some devices (e.g., Cable
Boxes or Satellite Receivers)
use two-digit channel
numbers. During
programming, press ENTER
or OK after entering a
channel number (e.g., 0 2
ENTER for channel 2). See
“Programming Favorite
Channel Scan” on page 10.
PROBLEM: Cannot find a working code
using the instructions in
“Searching For Your Code”
on page 9.
SOLUTION: See our website
(www.radioshack.com) for
help or take the remote to
your local RadioShack
store.
PROBLEM: Changing channels does not
work properly.
RS 4in1 Kam User Manual.fm Page 14 Friday, March 4, 2005 9:09 AM