Filter
Top Products
4-IN-ONE REMOTE POWERED BY KAMELEON
8 Programming A DVD Player/ VCR Combo
4. Use the “Manufacturer’s Codes
(Códigos del Fabricante)” (starting
on page 43) to locate the type of device
and brand name and then use the
number keys to enter the first four-digit
code for your device. The IR segment
will flash once for each digit pressed. If
the code was successful, the IR segment
will flash twice at the last digit pressed.
N
OTE:
If the IR segment displays one long
flash instead, a mistake has occurred. Try
entering the same code again
.
5. Aim the remote control at the device and
press POWER. The device should turn
off. If it does not, repeat steps 3 to 5,
trying each code for your brand until
you find one that works. If it still doesn’t
work, try “Searching For Your Code” on
page 9.
6. If desired, repeat steps 2 through 5 for
each device you want to control.
7. For future reference, write down each
working device code in the following
boxes:
CBL/SAT Code:
Device Type:_______________________
TV Code:
Device Type:_______________________
DVD Code:
Device Type:_______________________
VCR Code:
Device Type:_______________________
PVR Code:
Device Type:_______________________
PROGRAMMING A DVD
PLAYER/ VCR COMBO
1. Turn on the device and insert a DVD.
NOTE: Please read steps 2 through 10
completely before proceeding. Before
starting step 2, review the “Setup Codes
For DVD Player/VCR Combos” (on page
47). Brands are listed alphabetically with
the codes in order of most popular models
first. Highlight or write down the devices
and the codes you wish to program.
2. Press DVD. The key will animate.
3. Press and hold P until the IR segment
flashes twice.
NOTE: If the display turns off due to
inactivity, the remote control will exit
programming and return to the last-
selected device menu screen. To start
programming again, repeat this step.
4. Use the “Setup Codes for DVD Player/
VCR Combos” (on page 47) to locate the
brand name and use the number keys to
enter the first four-digit code for your
device. The IR segment will flash once
for each digit pressed. If the code was
successful, the IR segment will flash
twice at the last digit pressed.
NOTE: If the IR segment displays one
long flash instead, an error has occurred.
Try entering the same code again.
5. Aim the remote control at the device and
press POWER. The device should turn
off.
6. If the code works, press OK. The IR
segment flashes twice.
7. (Optional) If you’ve located a setup code
that works, but it also has a separate
VCR code as listed on page 55, you’ll also
need to program it into the remote
control to access VCR controls, as
follows:
RS 4in1 Kam User Manual.fm Page 8 Friday, March 4, 2005 9:09 AM