Filter
Top Products
25. If an outside antenna or cable system is connected to the TV, be sure the antenna or cable system is grounded to provide
some protection against voltage surges and built-up static charges. Section 810 of the National Electrical Code,
ANSI/NFPA NO.70, provides information with respect to proper grounding of the mast and supporting structure,
grounding of the lead-in wire to an antenna discharge unit, size of grounding conductors, location of antenna discharge
unit, connection to grounding electrodes, and requirements for the grounding electrodes. (See Diagram Figure A.)
24. To reduce the risk of electric shock, the grounding of center pin of plug must be maintained.
Safety Strap
Caution: Pushing, pulling or climbing on the TV may cause the TV falling. Do not let chlidren climb or hang on the TV.
Always place the TV on a sturdy, level, sable surface that can hold the weight of TV. And if possible, secure the TV according
to the instruction below (Note: The fastening components such as screws are not supplied with TV).
Step one: Insert the M6 mounting screws into the upper two wall mounting screw holes and fasten them (Figure A).
Step two: Insert anchors to wall and connect the bolts and anchors with ropes or chains (Figure B).
Safety Precautions
iii
ANTENNA
LEAD IN
WIRE
GROUND
CLAMP
GROUNDING CONDUCTORS
(NEC
SECTION 810-21)
GROUND
CLAMPS
POWER SERVICE GROUNDI
NG
ELECTRODE
SYSTEM
(NEC ART 250, PARTH)
ELECTRIC SERVIC
E
EQUIPME
NT
ANTENN
A
DISCHARGE UNI
T
(NEC SECTION 810-20)
Diagram Figure A
Figure A Figure B
23. WARNING: To prevent injury, this apparatus must be securely attached to the floor/wall in accordance with the
installation instructions.
M6 Screws
Wall