Filter
Top Products
33
Graphics throughout this User’s Guide are for representation only.
No sound or distorted sound
•Make sure your player is connected properly. Make sure all cables are securely inserted
into the appropriate jacks.
•Make sure you’ve connected the audio cables (red and white).
•Turn your TV to its Video Input Channel (go to page 9).
• Sound is muted when you’re using search features (fast forward, reverse, etc.).
• If you connected an audio receiver to your DVD Player, make sure you chose the correct
input setting on the receiver.
Remote control won’t work
•You might be in the wrong mode.To operate your DVD Player, press the
DVD button on
the remote before you press any other buttons. If you’re operating the TV, press the
TV
button first, etc. (this remote operates most RCA, GE, and Proscan TVs).
• Check battery installation— the direction of the + and – on the batteries must match
information in battery compartment cover.
• Insert new batteries in the remote.
•Operate the remote control at a distance of no more than 20 feet.
• Remove any obstacles between the remote and the DVD Player. If your DVD Player is in
an entertainment cabinet, the glass doors might obstruct the remote control from
operating the DVD Player. Open the doors.
• Drain the remote’s microprocessor — remove the batteries; press and hold the
1 button
for 60 seconds; replace the batteries and try the remote again.
Can’t advance through a movie
• You can’t advance through the opening credits and warning information that appear at the
beginning of movies because the disc is programmed to prohibit that action.
The invalid icon appears on screen
The feature or action cannot be completed at this time for one of the following reasons:
the disc’s software restricts it; the disc’s software doesn’t support that feature (e.g.,
angles); the feature is not available at the moment; you’ve requested a title or chapter
number that is out of range.
The picture is distorted
• Did you connect your VCR to the DVD Player? Disconnect it, and connect the VCR
directly to the TV and the DVD Player directly to the TV. See chapter 1 for correct setup
and connection information.
• The disc might be damaged.Try another disc.
• If you’re using
FORWARD or REVERSE buttons, it is normal for some distortion to appear
while scanning.
A screen saver appears on the TV
•Your player is equipped with a screen saver that appears on the TV after your player has
been idle for several minutes.To make it disappear, press
STOP or CLEAR on the remote.
Subtitle and/or audio language is not the one selected from the initial setting
• If the subtitle and/or audio language does not exist on the disc, the initial settings will not
be seen/heard.The disc’s priority language is selected instead. Set the subtitle and/or audio
language manually through the Info Display or the player menu.
Disc tray won’t open
•Press and hold STOP key on front of player, and then press and hold the ON/OFF button
on the remote control. Keep pressing both buttons simultaneously for 2 seconds.
Additional Information