Filter
Top Products
12
Chapter 1: Setup and Connections
Install Batteries in the Remote
1. Remove the battery compartment cover on the back of the remote.
2. Insert new batteries. Match the polarities (+ and –) on the batteries with the diagram on the remote.
3. Put the battery compartment cover back on the remote.
Important Battery Information
• If you’re not going to use the remote for a month or more, be sure to remove the batteries because they can leak and cause damage.
• Dispose of batteries in the proper manner, according to federal, state, and local regulations.
• Any battery may leak electrolyte if mixed with a different battery type, if inserted incorrectly, if all batteries are not replaced at the same time,
if disposed of in fire, or if an attempt is made to charge a battery not intended to be recharged.
• Discard leaky batteries immediately. Leaking batteries can cause skin burns or other personal injury.
Point the Remote in the Right Direction and Put it in DVD Mode
When you want the remote to operate the Digital Media Recorder, point the remote at the Digital Media Recorder, not the TV. The remote has to
be pointed in the correct direction and toward the correct component in order for the remote control’s signal to communicate with the sensor on
the component. Make sure there is a clear path between the remote control and the component you want to operate, so the signal isn’t blocked.
Make sure the remote is in DVD mode — press the DVD button.
Turn on the TV and Digital Media Recorder
1. Turn on your TV and tune the TV to the correct Video Input Channel (if you don’t know which channel is your the Video Input channel, go
to page 16 for help). If your TV is RCA, GE, or Proscan just press the INPUT button to get to the Video Input Channel.
Note: You can program your remote to operate most brands of remote controllable TVs. Instructions are on page 19.
2. Press the DVD button on the remote control to put it in the correct mode, and turn on the Digital Media Recorder.
OPEN
INPUT
LIVE
ANTENNA
DVD ON • OFF TV
VCR AUDIO AUX SAT • CABLE
CH +
ANGLEMUTE
CH -
ZOOM GO BACK
OK
INFOGUIDE
CLEARMENU
123
456
789
0
AGAIN ADVANCE
REVERSE FORWARDPLAY
RECORD PAUSESTOP
VOL
VOL
Up arrow button
Right arrow
button
OK button
Left arrow
button
Down arrow
button
Use the arrow buttons on the remote to
move through on-screen menus and
highlight different options. Press the
OK button to select a menu item that is
highlighted.
Complete the Interactive Setup
The next few pages step you through the series of screens that will appear the first
time you turn on your Digital Media Recorder.
Use the remote control to follow the on-screen instructions. The arrow buttons
move the on-screen highlight in the corresponding directions on the screen (up,
down, left, right).
Press the OK button to select a highlighted item.
Notes:
You can access the setup screens from the main menu. If you move, get a different
program provider for TV shows, or change your connections, you’ll need to
complete the Interactive Setup again.
If you don’t see the Language selection screen (below) the first time you turn on
the Digital Media Recorder, make sure you’ve tuned your TV to the Video Input
Channel that corresponds to the way you’ve connected the TV to the Digital Media
Recorder. If you need help, go to page 16.
1) Select on-screen menu language
If you want the on-screen menus to appear in English, press the OK button on
the remote control. If you prefer another language, press the arrow down button
until that language is highlighted. Press OK to select the language.