Filter
Top Products
Connections & Setup
10 Chapter 1
Removing the Front Panel Piece
The front panel piece is removable to allow access to the jack panel, mirror adjustment screws, and lamp door. The mirror
adjustment is discussed on page 59 and the lamp replacement is discussed on page 76. To remove the front panel piece,
grasp one end of the panel and pull out until the tab pops out of the hole. Continue to slide your fingers down the panel as
the tabs pop out of place, until it is unattached. Reattach the front panel piece by lining up the tabs with the holes, starting
at the bottom. Then push the tabs back into place.
Jack panel door Front panel piece
Jack panel shelf
Front panel piece
Accessing the Jack Panel
The jack panel is located towards the back of the TV. You can access these
jacks from the front by removing the front panel piece as described above, or
from the back by removing the jack panel door.
Locate the jack panel door on the back of the TV on the right bottom side. To
remove the door, pull the tab towards the left, and then pull the door open.
Reattach the jack panel door by fitting the tabs on the left into the slots and
then close the door until it snaps into place.
Connect the cables to the jacks by putting the cables through the hole, as
shown to the left. Then the cables can be placed on the shelf at the back of the
TV.
Mirror adjustment screws Lamp door
Tab
holes
Jack panel access